Hot Oil Circulation Pump

WRY series hot oil pump has been widely used in heat carrier heating system and has entered the petroleum, chemical, rubber, plastics, pharmaceutical, textile, printing and dyeing, road construction, food and other industries, mainly used for conveying weak corrosion and high-temperature fluid without solid particles, using temperature is less than or equal to 350 DEG C, is an ideal hot oil circulation pump.
WRY,,,,.
WRY series hot oil pump is the second generation product based on the research and development of our company after learning and absorption of foreign oil pump. The basic structure is single-stage single suction cantilever leg supporting, the pump inlet is axial suction, export center vertically upward, mounted on the base with motor.
WRY,,,,.
WRY series hot oil pump is supported by the ball bearings at the both ends supported structure, front end lubricated by lubricating oil, back end lubricated by grease, in the middle there is a guide pipe, for observation the sealing condition at any time and the recycling of conduction oil.
,,,,,,.
The traditional water cooling structure is changed to natural cooling structure, so that the structure is simple, the volume is small, the operation cost is saved, the performance is good, and the use is reliable.
WRY:(1),,,,,.
WRY series hot oil pump:
(1) adopts packing seal and mechanical seal combination, and the packing seal packing with high temperature resistance, with good thermal adaptability, and mechanical seal with high mechanical strength, good wear resistance of hard alloy material, to ensure the sealing performance under high temperature conditions.
(2)(PTFE),,25,.
(2) using the third generation PTFE (PTFE) to do lip type seal, so that the sealing performance leap-forward, 25 times more reliable than the rubber seal reliability, corrosion resistance is very strong.