In the road automobile industry, hydrogen energy sources, including hydrogen fuel cells, have been developed by the major automobile companies as a cheap, low-pollution alternative energy source and have mature products. For the non-road engineering vehicle industry, Toyota and Linde of Japan And other world-class companies have also begun to use hydrogen fuel cells as the power of forklifts and engineering trucks. At the power show not long ago, Toyota forklifts exhibited their hydrogen fuel cell energy forklifts.
This cylinder valve thread standard meets the requirements of domestic steel cylinders and can be seamlessly integrated into any existing capacity hydrogen cylinders, greatly shortening the development cycle. It can be foreseen that with the support of energy conservation and emission reduction, the new energy industry will be supported. Under the policy support conditions, hydrogen energy as a vehicle power will be developed rapidly in the future. Users will enjoy the benefits of zero pollution and low cost of use, just like using electric forklifts or new energy vehicles.
In the Indian automotive market, this cylinder valve has been loaded and mass produced. At present, this hydrogen cylinder valve has been exclusively sold by Guangqing Gas Technology Co., Ltd. in mainland China and Taiwan. The following are related introductions and parameters:
The cylinder valve is specially designed for hydrogen storage and can withstand pressures up to 350 bar. It includes a built-in TeleflexGFI switch solenoid valve to enhance system safety. Available in 12V and 24V models. Built-in pressure relief valve, such as temperature and pressure can be used to protect the cylinder from pressure relief and strengthen the safety of the cylinder.
parameter
Gas source | hydrogen | |
Normal storage pressure | 5075 psi | 350 Barg |
Maximum overload pressure | 6350 psi | 438 Barg |
Minimum starting pressure | 20,300 psi | 1400 Barg |
Inlet flow | 0.7 Cv. | |
Export flow | ~1.2 Cv. | |
Hydrogen valve parameters | Solenoid valve 12V or 24V | |
range of working temperature | -40~85°C | |
Pipeline and leak standard | <100 ppm | |
Systemwide leak standard | <100 ppm | |
Safety relief valve | Open at pressure >438barg or temperature >110±5°C | |
Fill check valve | 350 bar | |
Warranty | Meet the three-year or 50,000-kilometre operation requirements of the entire vehicle | |
High pressure valve interface | Meet SAEJ1926-1 | |
IP rating | IP67 | |
Amrta air handling unit with colorful steel and galvanized panel as its interior and exterior panel. Inner stuff is the high density polyurethane foam. Case thickness 25mm or 50mm to strength the unit and avoid air leakage.
Advanced Internal Equipment
1.Direct Driven and No Volute Frequency Conversion Fan Using authoritative certificate and high efficient no volute frequency conversion fan with high transfer efficiency, no belt wear and stable operation. Meanwhile, the no volute fan is open-type structure and convenient to maintenance and clean, especially applied to the clear room.
2.Naked Tube Heater. The heat exchang pipe of the heater is made of stainless steel, smooth surface, without spiral fin, preventing accumulation of dust and breeding of bacteria.
3.Flexible and high-efficient antibacterial heat exchanger. The heat exchanger is designed by special computer auxiliary software, whose performance strictly meets the requirement of national standard of clean room. Hydrophilic aluminum fin or copper fin is applied, thus avoiding the air through the coil to take the condensing water covering on the surface of coil away. Meanwhile it also can prevent the breeding of bacteria.
4.Steam-type Humidifier. The unit uses electrode and dry steam to humidify, avoiding the humidified circumstance to keep from the breeding of bacteria.
5.High quality filter. The unit can use various filters with different degrees to meet customer's requirements, thus optimizing its performance.
6.Optimized Design. Fan placed in the front make sure the unit is under positive pressure to prevent the outside air from leaking, which will pollute the clear air in the unit. And the condensate water can be drained because of positive pressure.
DX Type Air Handling Unit
DX Type Air Handling Unit,DX type Modular Air Handling Unit,Special Air Handling Unit,Hygiene Grade Air Handling Unit
Jinan Amrta Air Conditioning Co.,Ltd , https://www.waterchiller.pl