The product has the following characteristics: First, it increases or maintains the tensile strength of the product while increasing the toughness of the plastic product, which is not possessed by other toughening agents. The second is to replace CPE (chlorinated polyethylene) and other tougheners in the processing of PVC materials. The third is to use appropriate amounts of toughening agents such as CPE, which can double the impact and toughness of plastic products, and increase or maintain the strength. Fourth, it has the function of plasticizing and promoting plasticization of plastic products, and can reduce the amount of processing aids. Fifth, compared with the commonly used additives, the price is cheaper, which can reduce the cost of plastic products.
Butterfly Valve is a valve which can be used for isolating or regulating flow. The closing mechanism takes the form of a disk. Operation is similar to that of a Ball Valve, which allows for quick shut off. Butterfly valves are generally favored because they are lower in cost to other valve designs as well as being lighter in weight, meaning less support is required. The disc is positioned in the center of the pipe, passing through the disc is a rod connected to an actuator on the outside of the valve. Rotating the actuator turns the disc either parallel or perpendicular to the flow. Unlike a ball valve, the disc is always present within the flow, therefore a pressure drop is always induced in the flow, regardless of valve position.
A butterfly valve is from a family of valves called quarter-turn valves. In operation, the valve is fully open or closed when the disc is rotated a quarter turn. The "butterfly" is a metal disc mounted on a rod. When the valve is closed, the disc is turned so that it completely blocks off the passageway. When the valve is fully open, the disc is rotated a quarter turn so that it allows an almost unrestricted passage of the fluid. The valve may also be opened incrementally to throttle flow.
There are different kinds of butterfly valves, each adapted for different pressures and different usage. The zero offset butterfly valve, which uses the flexibility of rubber, has the lowest pressure rating. The high performance Double Offset Butterfly Valve, used in slightly higher-pressure systems, is offset from the centre line of the disc seat and body seal (offset one), and the centre line of the bore (offset two). This creates a cam action during operation to lift the seat out of the seal resulting in less friction than is created in the zero offset design and decreases its tendency to wear. The valve best suited for high-pressure systems is the Triple Offset Butterfly valve. In this valve the disc seat contact axis is offset, which acts to virtually eliminate sliding contact between disc and seat. In the case of triple offset valves the seat is made of metal so that it can be machined such as to achieve a bubble tight shut-off when in contact with the disc.
Butterfly Valve
API Butterfly Valve, JIS Butterfly Valve, DIN Butterfly Valve, High Performance Butterfly Valves
Zhejiang Zhongcheng Valve Co.,Ltd. , http://www.apivalvestar.com