Tips for Keeping Your Electric Forklift Charger Live Longer:
Unauthorized disassembly and decomposition of the charger; first, the charger must not be disassembled and disassembled without authorization; the charger should be placed vertically, preferably in a dry, ventilated environment, away from moisture, away from flammable and explosive materials; if the battery is full, first Disconnect the input AC power, and then disconnect the connection between the charger and the battery; if no one or long-term use, you must disconnect the AC power; do not cover the charger during charging, the use of the ambient temperature is not greater than 40 °C; this The charger is limited to indoor use and should not be exposed to rain. It is forbidden to charge the non-rechargeable battery; the interval between two booting is not less than 10 seconds. The charger should always be kept clean to prevent the intrusion of dust and moisture. When not in use for a long time, it should be placed in a dry and ventilated room and covered with a hood. After a period of time, it should also go on electricity to go. During the charging process, the ventilation shutters on the casing cannot be shielded to ensure that the heat generated in the charger spreads in time. After the fuses in the input and output circuits are blown, they must be replaced according to the required specifications. The fuse should not be too thick and never be replaced with a wire. When the AC input voltage is 110 volts, the input current is 10.8 amps. When the AC input voltage is 220 volts, the input current is 5.4 amps. When two rectifiers are working at the same time, the output current can reach 12A. When a rectifier is working alone, the output current does not exceed 6A. The appropriate fuse should be selected based on the input and output currents. Brushes of transformer sliding contacts should be kept in good contact. When the brush exposed part of the copper frame is less than 2 mm, it should be replaced in time.
Shelf system:
Shelves can be equipped with different warehouse storage systems based on customer's characteristics and requirements, such as drive-in shelving warehouse system, narrow-aisle racking warehouse system, double-in-depth shelf warehouse system, shuttle racking warehouse system, gravity racking warehouse system, rear Push racking warehouse system, electric mobile racking warehouse system and so on.
Drive-in shelving warehouse system
Shelving Ordinary Forklift: With a full-shelf, no dedicated forklift access, the forklift enters the shelves to access the goods.
Narrow laneway shelf warehouse system
Three-way stacking forklift trucks with shelves: The conventional rails use unequal angles and narrow channels, inheriting all the advantages of the beam-type racking system.
Double depth warehouse system
Scissor-type forklift with: Shelves designed to store two rows of parallel, height up to 8 meters, 50% of the picking.
Shuttle rack shelf system
Shelf common forklift shuttle car with: according to the instructions by the shuttle vehicle in the shelf access, inventory and other operations.
Gravity shelf warehouse system
Shelf Ordinary Forklift Roller Track Matching: Forklifts carry the goods to the high end of the shelf, and the goods are stored under their own weight.
Push-back shelf warehouse system
Shelf trolley matching: The front and rear beams are overlapped by multiple layers of trolleys, stacked stacks of goods are placed on the trolleys from the outside, and the stored items are then pushed into the original goods.
Electric Mobile Shelf Warehouse System
Shelf motor trolley matching: Through the motor-driven carrier trolley, the trolley is placed on the shelf, frequency control, and the shelf is extremely stable from start-up to braking, and the safety is guaranteed.
The above is about the forklift's charger and shelf system related knowledge.
Concrete Truss,6M Concrete Truss Screed,3M Concrete Truss Screed,3M Concrete Truss Screed Machine
Shandong Storike Engineering Machinery Co., Ltd. , https://www.storikemachinery.com